Clarity W-1000 - Manual (Page 20)

W-1000 Page 20
—Make sure that TONE/PULSE switch
is not set in the middle. Slide the switch
fully to the left or the right.
—If you have the TONE/PULSE switch
set to TONE, make sure that you have
TouchTone service from your local
phone company.
• Phone Doesn’t Dial Out On
First Attempt
—Your phone may be at the end of a
long line of phones, due to the way the
phone company installed the wiring in
your neighborhood. In this case, your
phone may not get enough power from
the phone line. Try waiting 3-5 seconds
after lifting the handset before dialing
the number. Wait for the sound level
indicator to light solid before dialing.
—Your new Clarity phone must charge
for two (2) hours before you can
program any numbers into it.
Trouble-Shooting Guide
Dialing Problems
• Can’t Dial Out
—Your Clarity phone will maintain its
memory for up to 12 hours during a
power loss. If you unplug the phone
from the telephone line for long periods
or lose your phone service for an
extended period of time you will need
to reprogram the phone.
Programming Problems
• Can’t Store Numbers Into
Memory
• Loss Of Numbers
Programmed Into Memory
E
N
G
L
I
S
H
W1000_User_Guide 11/15/99, 9:38 PM 20