Rane AC 22B (1998 version) - Manual (Page 4)

Manual-4
FRONT PANEL: MONO 3-WAY CONFIGURATION
Observe the labels below the controls for Mono operation.
ቢ POWER switch: Self-evident.
ባ POWER indicator: When this yellow LED is lit, the unit is ready to operate.
ቤ CHANNEL 1 MASTER LEVEL controls the overall Level without altering the relative settings of the HIGH, MID and
LOW Outputs. Unity gain for all Level controls is at “7”.
ብ LOW LEVEL controls the Level of signal going to the LOW Output.
ቦ LOW MUTE: When pressed to the in position, all signal is removed from the LOW Output. This eases tune-up procedure,
as described on pages Manual 7-13.
ቧ LOW DELAY control adds from 0 to 2 ms of time Delay to the LOW Output only. This allows a low frequency driver to
be electronically phase-aligned with a high frequency driver whose diaphragm is situated behind the low frequency dia-
phragm. Refer to Time Delay Adjustment on page Manual-6 for the procedure.
ቨ LOW/MID FREQUENCY: This 41-detent selector determines the crossover Frequency between LOW and MID Outputs.
The detents will assure maximum accuracy and consistency between Channels. Refer to Selecting Crossover Frequencies
on page Manual-6 to determine proper setting for your particular system.
ቩ MID LEVEL controls the Level of signal going to the MID Output.
* NOTE: The Channel 2 MASTER LEVEL control is automatically bypassed internally when the System Mode switch is set to
MONO 3-WAY as shown on the facing page. Adjusting this control will have no effect in the MONO mode.
ቪ MID MUTE: When pressed to the in position, all signal is removed from the MID Output. This eases tune-up procedures,
as described in pages Manual 7-13.
ቫ MID DELAY control adds from 0 to 2 ms of time Delay to the MID Output only. This allows a mid frequency driver to be
electronically phase-aligned with a high frequency driver whose diaphragm is situated behind the mid frequency diaphragm.
Refer to Time Delay Alignment on page Manual-6 for procedure.
ቭ MID/HI FREQUENCY sets the crossover Frequency between the MID and HIGH Outputs. Refer to Selecting Crossover
Frequencies on page Manual-6.
ቮ HIGH LEVEL controls the Level of signal going to the HIGH Output only.