Rane SEQ 30S and 30L (2003 versions) - Manual (Page 3)

Manual-3
1 LEFT & RIGHT INPUTS
Choose between the balanced XLR or the balanced/unbalanced ¼" tip-ring-sleeve jacks, but only use one. Inserting a ¼" tip-
sleeve jack will work, however—always use balanced lines when connecting cables over 10 feet (3 meters) in length. Consult the
Sound System Interconnection section included in this booklet.
In agreement with IEC and AES/ANSI standards, XLR wiring convention is pin 2 Positive (hot), pin 3 Negative (cold), and pin 1
Signal ground (for unbalanced use). Pin 1 and the connector case or shell are tied to chassis ground.
2 LEFT & RIGHT OUTPUTS
Use the balanced XLR or the unbalanced ¼" tip-sleeve jacks. It is permissible to simultaneously use both types of Outputs to
drive two devices, such as an amplifier and a recorder. XLR wiring is the same as the Inputs.
REAR PANEL DESCRIPTION
MADE IN U.S.A.
RANE CORP.
OUTPUTS
SEQ 30L
INPUTS
RIGHT RIGHT LEFT LEFT
UNBALANCED BAL / UNBAL UNBALANCED BAL / UNBAL BALANCED BALANCED BALANCED BALANCED
ACN 001 345 482
50/60 Hz
12 WATTS
120 V
FOR CONTINUED
GROUNDING PROTECTION
DO NOT REMOVE SCREW
WARNING
TO REDUCE THE RISK OF FIRE
OR ELECTRICAL SHOCK DO
NOT EXPOSE THIS EQUIPMENT
TO RAIN OR MOISTURE. DO
NOT REMOVE COVER. NO
USER SERVICEABLE PARTS
INSIDE. REFER SERVICING TO
QUALIFIED PERSONNEL.
WIRING
3-PIN XLR:
PIN 2 = (+), PIN 3 = (–), PIN 1 = CHASSIS, SHIELD
¼" PHONE, BALANCED:
TIP = (+), RING = (–), SLEEVE = CHASSIS, SHIELD
¼" PHONE, UNBALANCED:
TIP = SIGNAL, RING = GROUND, SLEEVE = CHASSIS, SHIELD
2 1
MADE IN U.S.A.
RANE CORP.
OUTPUTS SEQ 30S INPUTS
RIGHT RIGHT LEFT LEFT
UNBALANCED BAL / UNBAL UNBALANCED BAL / UNBAL BALANCED BALANCED BALANCED BALANCED
N108
50/60 Hz
12 WATTS
120 V
FOR CONTINUED GROUNDING PROTECTION
DO NOT REMOVE SCREW
WARNING
TO REDUCE THE RISK OF FIRE
OR ELECTRICAL SHOCK DO
NOT EXPOSE THIS EQUIPMENT
TO RAIN OR MOISTURE. DO
NOT REMOVE COVER. NO
USER SERVICEABLE PARTS
INSIDE. REFER SERVICING TO
QUALIFIED PERSONNEL.
WIRING
3-PIN XLR:
PIN 1 = CHASSIS, SHIELD,
PIN 2 = (+), PIN 3 = (–).
¼" PHONE, BALANCED:
TIP = (+), RING = (–),
SLEEVE = CHASSIS, SHIELD.
¼" PHONE, UNBALANCED:
TIP = SIGNAL, RING = GROUND,
SLEEVE = CHASSIS, SHIELD.
2 1