Rane TTM 56 - Manual (Page 6)

Manual-
MIC
LEVEL
HIGH
LOW
HIGH GAIN GAIN HIGH
MID
EQ EQ
MID AUX OUT
LOW
FlexFX FlexFX
LOW PHONES LEVEL
PGM 2 PGM 1
MASTER OL
10 0
+12 -12
+12 -12
+6 OFF
+6 OFF
+6 OFF
+6 OFF
+6 OFF
+6 OFF
10 0
6 4
2 8
6 4
2 8
10 0
6 4
2 8
10 0
6 4
2 8
10 0
6 4
2 8
10 0
6 4
2 8
AUX IN
+10
+7
+4
+2
0
-4
-2
-7
-10
-20
10 0
6 4
2 8
PERFORMANCE MIXER
FAST
SLOW
TTM 56
L
REVERSE
CONTOUR
REVERSE
MODE 1
MODE 2
CONTOUR
MODE 1
MODE 2
CHANNEL REVERSE
TRANSFORM TRANSFORM
STEREO HOUSE
MONO PGM1 / PGM2
A B
PAN R DRY WET L PAN MASTER / CUE R
PGM 1 CUE PGM 2
REVERSE MODE 1 MODE 2
FAST
SLOW
CONTOUR A CROSSFADER CONTOUR B HEADPHONES
MODE REVERSE
PWR
CHANNEL REVERSE switch allows
the left-hand or right-hand Fader
to alternately control PGM 1 or
PGM 2. (Don't confuse with the
program fader REVERSE switch,
see below.)
TRANSFORM switches provide two
functions:
• PHONO / LINE source selection
for PGM 1 and 2.
• Quick cut between the used and
unused input. The switches are
easily field replaceable and may be
rotated in 45° increments. See page
Manual-10 for instructions.
Faders
The program faders and crossfader are magnetic, non-contact
faders. This means No travel noise or bleed ! The electrical
performance of the faders is unaffected by use. The program
faders and crossfader each have their own CONTOUR,
REVERSE (hamster) and MODE controls. Magnetic
faders are very different from what you are used to. Read
Maintaining Magnetic Faders on pages Manual 8-9.
Program fader MODE switches: allow selecting two sets of
curves. MODE 1 gives the familiar stereo fader response.
MODE 2 gives left/right pan effect.
Program fader CONTOUR controls: allow smooth, continu-
ous adjustment of contour for both MODE 1 and MODE
2. The range of control is from SLOW blend to FAST cut.
Program fader REVERSE switches change the direction of
the program faders. When the reverse switch is engaged, up
is down and down is up (hamster).
CROSSFADER MODE switch allows selecting two sets of
crossfader curves. MODE 1 gives the familiar PGM 1 /
PGM 2 crossfade response. MODE 2 gives a center cut
response (PGM 1 and PGM 2 off in the center).
CROSSFADER CONTOUR A & B provide independent
control for each side of the crossfader. This allows a fast cut
on one side and slow blending on the other (or any combi-
nation you choose).
Meters
Meters provide switchable true stereo Master Mix or dual-
mono PGM1 / PGM2 indication of Pre-Program fader
signal levels. Ten-segment resolution is provided with a one
second, peak hold. Use the meter to set the GAIN controls.
With the program fader set to maximum, the input GAIN
should be set to indicate an average level of about +4 dB.