OFNA Racing Jammin X1 CRT PRO - Manual (Page 25)

55
56
20
3x12mm
Hex Screw
40672
Wing
Drill two 7mm holes for
mounting.
40542
Countersunk
Plastic Washer
3mm
Nylon Nut
ASSEMBLY OF THE WING
..........X2
..........X2
94004
3x12mm
Hex Screw
94041
3mm
Nylock Nut
Cut out the body as shown.
Use a neutral detergent to
remove any dirt and oil.
Mask the windows from
the inside with masking tape.
Paint the body with
polycarbonate spray paints.
Spray Paint
Before cutting and making holes on the body,
put the unpainted body on the chassis
to confirm the mounting position and
location for holes and cutouts.
Making two holes in the front and
one hole in the rear for body posts.
8mm
8mm
Cut out for engine.
Hole for fuel tank.
CUTTING OUT THE BODY AND PAINTING
10803
Body Reamer
( Not included)
40620
Body w/
Decals