OFNA Racing Titan Deluxe RTR - Manual (Page 10)

36860
5x35mm
Turnbuckle
40201
Upper Arm
36850
7mm Ball
36690
7mm
Plastic
Ball End
ASSEMBLY OF THE REAR UPPER ARM
31307
11mm
Ball & Screw
31304
Rear Hub
( Ball Type )
31305
Plastic Washer
31306
12mm
Alum. Hex Screw
Screw Cement
20245
Wheel Hub,
Orange
36055
2.5x16.8mm
Pin
36081
8mm
Rear Wheel Axle
36053
8x16mm
Ball bearing
36053
8x16mm
Ball bearing
40215
Rear
Drive Shaft
(91.5mm)
40215
Rear Drive Shaft
(91.5mm)
40023
4mm
Lower Arm
Shaft
30702
3x25
Hex Screw
35313
M3
Nylon Nut
90020
2.5mm
E-Ring
90020
2.5mm
E-Ring
90021
3mm
E-Ring
3mm
E-Ring
Upper Arm
Washer
ASSEMBLY OF THE REAR HUB
ASSEMBLY OF THE REAR HUB
AND SUSPENSION ARMS
INTO GEAR BOX
Assembly of the right and left hand side
are the same.
Assembly of the right and left hand side
are the same.
Assembly of the right and left hand side
are the same.
90026
5x5mm
Set Screw
*Builds two arms for left and right hand side.
*Builds two hubs for left and right hand side.
8mm
*Insert the rear drive shaft before assembly
the rear lower arm. 40202
Rear Lower Arm
90021
Note: This Axles part is not needed
if your kit has CVA joint for rear instead.