OFNA Racing Ultra LX 1e - Manual (Page 2)

TOOLS NOT INCLUDED IN THE KIT
INCLUDED IN THE KIT
REQUIRED FOR OPERATION
Phillips Type Screw Drivers ( L )
Phillips Type Screw Drivers ( S )
Cutter
Curved Scissors
Knife
CA Glue
Cross Wrench
Masking Tape
Spray Paints
Brush
Precision Caliper
1.5mm Allen Wrench
2mm Allen Wrench
2.5mm Allen Wrench
4mm'5mm Allen Wrench
17mm Wheel
Nut Wrench
Needle Nosed Pliers
NOT INCLUDED
MAMBA MONSTER 1/8 ESC WITH
2650KV BRUSHLESS MOTOR
RADIO CONTROL UNIT
Note: Carefully read the instruction manual of your
2 channel radio controller before using.
Radio must be set at neutral position
before installing in the kit.
SEQUENCE TO SET NEUTRAL
Install AA batteries in Radio.
Extend the antenna.(Transmitter)
Install batteries into Car receiver .
After installing the battery, connect the
battery box.
Extend the antenna. (Receiver)
Set the trim-lever at center.
Turn on the switch. (Transmitter)
Turn on the switch. (Receiver)
Make sure the servos are in command.
When the operation stick is in neutral,
servo horns must be in neutral as will.
*Adjustment can be made by re-
installing the servo horn.
Turn off the switch. (Receiver)
Turn off the switch. (Transmitter)
Retract the antenna. (Transmitter)
11 11
12
13
SUITABLE SERVO SIZE
29mm - 42mm
15mm - 21mm
m
36mm-4
1 m
(NOT INCLUDED)