OFNA Racing Ultra LX 2 - Manual (Page 22)

16
37 ASSEMBLY OF THE BRAKE LINKAGE INTO BRAKE LEAVE
94033
M3x3
Set Screw
.....x2
38 ADJUSTING THE ENGINE CONTROL LINKAGES
Approx. 1mm gap
(Neutral) (Throttle High) (Brake)
•Turn on the Transmitter then Receiver and set the
engine Control Servo Trim to the neutral position.
•Adjust the idling adjusting screw on the Carburetor
to be open approx. 1mm gap.
Idling adjusting
Screw
•Adjust both of the 10300 Engine Control and Brake
linkage accordingly.
•Adjust the Engine while it is not running.
•Adjust the Servo-Horn mounting position for the
carburetor to be full open.
•Change the pivot mounting position on the servo
horn in case the Carburetor is not opening fully or
if it is opening excessively. Or if available on the
transmitter, adjust the Throttle high end point. •Adjust 10300 so the brakes work smoothly.
if the brakes apply too much or not enough,
adjust 36140 accordingly. Or if available on the
transmitter, adjust the High-End Brake adjustment.
•Adjust 36140 to Change the front or Rear Brake.
36140
10300
0.5mm
Approx. 0.5mm
Carburetor is
Opening fully
10300
10300
Use the screw
provided with
your servo.
3x3mm
10300
10769