OFNA Racing Ultra MBX Comp - Manual (Page 34)

OFNA POWER STARTER SYSTEM
Setting up
Radio Check
Car Check
Read instruction manual carefully.
Open and remove kit.
Place car on car stand or block, this enables free
spinning / turning of wheels.
Charge receiver battery, you should trickle charge
your batteries overnight.
Check batteries make sure they are fully charged
(batteries are low if light is flashing). Running
car on low batteries could cause a run-away car.
Set trims(adjustments) on remote to neutral.
If steering trims are not set car will wander left or right.
If throttle trims are set wrong on throttle it could cause
high idle.
Place receiver battery in car.
Check throttle linkage, make sure when remote is
on, car does not go to full throttle. If linkage is
wrong, car will run-away, make sure that linkage
is in the neutral position. OFNA is not responsible
for damage sustained in run-away accidents.
Test throttle, pull trigger.
When trigger is pulled servo should move out and
brakes should move forward. If opposite position
happens when checking servo’s there is switch
on remote that needs to be reversed (servo
reverse switch).
Test transmitter wheel: turn transmitter wheel left,
car wheels should turn left, turn transmitter wheel
right, car wheels should turn right. If opposite
happens click the servo reverse switch on the
remote.