Beep setup, Error message – OFNA Racing 91849 DigiPeak 3 User Manual
Page 6

TONE ON
TONE OFF
Beep Setup
+
-
TONE ENABLE
TONE 'ENABLE'
TONE 'DISABLE'
TONE ENABLE
TONE DISABLE
LCD Display
Problem
Factor
[Error]
The output terminal is
REVERSE POLARITY
connected inversely to the
polarity of the battery pack.
[Error]
Short circuit protection for
OUTPUT SHORT
the output terminal.
[Error]
The battery pack is not
1.Battery pack fail.
OPEN CIRCUIT
connected to the charger
2.Battery pack disconnect
before charging.
charger.
[Error]
When the number of the
The cell number you select
OVER VOLTAGE
battery pack >select number, doesn't match the battery
the LCD display will show
pack.
"[Error] OVER VOLTAGE".
[Error]
When the number of the
The cell number you select
LOW VOLTAGE
battery pack <select number, doesn't match the battery
the LCD display will show
pack.
"[Error] LOW VOLTAGE".
INPUT POWER
Input voltage too low.
1.DC input voltage is lower
VOLTAGE ERROR
than 10.5V.
2. Power is overloading in
AC mode of the charger.
If the error cannot be fixed,
call the OFNA costumer support at 949-586-2910.
Error Message
6