Pigtronix Dual Expression pedal - Manual (Page 2)

Mission Enginî ring Inc.
www.missionengineering.com
[email protected]
©
Mission Engineering Inc. 2013. Trademarks, registered trademarks,
product names, logos and other materials are the property of their
respective owners.
Saþ ty
In ru ions
 Read, Keep & Follow these instructions

Heed all warnings
 Clean only with dry cloth
 Do not use this apparatus near water
 Do not expose the apparatus to dripping or
splashing and ensure that no objects filled with
liquids, shall be placed on the apparatus
 WARNING: To reduce the risk of fire or electric
shock do not expose this apparatus to rain or
moisture
 Unplug this apparatus during lightning storms or
when unused for long periods of time
 Do not block any ventilation openings. Install in
accordance with the manufacturer’s instructions
 Do not install near any heat sources such
as radiators, heat registers, stoves, or other
apparatus (including amplifiers) that produce
heat
 Only use attachments/accessories specified by
the manufacturer
 Prolonged listening at high volume levels may
cause irreparable hearing loss and/or damage.
Always be sure to practice “safe listening.”
 Refer all servicing to qualified service personnel.
Service is required when the apparatus has been
damaged in any way, such as:
- power-supply cord or plug is damaged
- liquid has been spilled or objects have fallen
into the apparatus
- the unit has been exposed to rain or moisture.
- the unit is dropped or the enclosure is
damaged
- the unit does not operate normally or changes
in performance in a significant way
ecifiÊ tions
Electrical Specifications
Potentiometer
Internal resistance – 25K Ohm
Taper – Linear
Polarity – Tip to wiper
Function – Voltage Divider
Usage Rating - > 1M cycles
Dimensions
Base length at longest point - 9.9”
Base width at widest point - 4.0”
Height at highest point including feet - 3.25”
Pedal length - 8.7”
Pedal width at widest point - 3.0”
Pedal width at narrowest point - 2.3”
Weight - 3.5lbs
U
Some devices will require proper configuration
before use with an expression pedal. Be sure to
read the User Manual for your device, and setup and
calibrate the expression pedal in accordance with the
instructions if necessary. Most manufacturers have
copies of their User Manuals available online.
Moving the rocker on the expression pedal will
change the parameters between minimum at heel
down and maximum at toe down. If used, both
outputs will vary simultaneously.
The direction of OUT1 can be reversed using the
small toggle switch at the front of the pedal. The
factory default is normal operation with the toggle
switched towards the rear of the pedal. To reverse
the direction of OUT1, switch the toggle towards
the front of the pedal. The sweep on OUT1 will
now be reversed; with maximum at heel down and
minimum at toe down. OUT 2 cannot be reversed.
Adju mEnts
The tension of the rocker can be adjusted using the
tension adjustment screw on the rear of the pedal
between the rocker and the base. Use the hex key
provided to tighten the adjustment screw until the
pedal remains in place. It maybe necessary to adjust
this screw every once in a while to compensate for
use and environmental conditions such as very hot or
cold weather, when the pedal has been stored for a
long period, or after shipping. Replacement hex keys
are available from Mission Engineering.