Pigtronix Tremvelope - Manual (Page 4)

Anatomy of the Tremvelope:
Jacks:
1. DC POWER 18-VOLTS – Use only the 18-Volt, 300mA, negative tip
power supply that came with your Pigtronix Tremvelope. Using the
wrong power supply is likely to result in a damaged pedal.
2. IN – Effect input, Plug in your instrument here.
3. OUT – Effect output, ¼ TS cable. Amp, mixer, or DI goes here.
4. STEREO OUT - Effect output, ¼ TS cable. Amp, mixer, or DI goes here.
5. TRIGGER – This audio input connects directly to the envelope follower.
Any signal plugged into this jack will override the input signal as the
source for the envelope modulation.
6. SPEED PEDAL - This is the TRS expression pedal input for controlling the
rate of the LFO. When an expression pedal is plugged into this jack,
the onboard speed knob is bypassed.
7. VOL / PAN - This is the TRS expression pedal input for using the
Tremvelope as a manually controled active volume pedal (in mono)
or panning device (in stereo).