Belt Drives TF-2000 - Manual (Page 2)

Fig. 5 Fig. 6
4. The pictures below refer to special bushing enclosed which is used only to install front pulley, it is a tool only
and must be removed after front pulley is installed. (Fig. 7)
Fig. 7
5. Refer to 3" Electric Start Installation for FXR #5 & #6 for proper procedure for alignment.
6. For final installation remove pressure plate and clutch pack for easier
handling and place belt on both pulleys and with special bushing in
simultaneously. (Fig. 8)
Fig. 8
7. Make sure writing on belt is facing towards you. (Fig. 9)
Fig. 9
INSTALLATION. (Fig. 10)
2
place,
(#4 above) and install belt drive onto engine and trans shaft
VERY IMPORTANT! APPLY RED LOCTITE ® TO SPLINED HUB OF REAR BASKET BEFORE FINAL