Sangean WR-15 (V1) - Manual (Page 8)

7
Power your radio
The AC power adaptor required for this unit should be  volts
DC at .A center pin positive. Insert the adaptor plug into the DC
socket on the rear of the radio. Plug the adaptor into a standard
manis socket outlet.
Important:
The mains plug or an appliance coupler is used as the means
of connecting the radio to the mains supply. The mains plug or
an appliance coupler used for the radio must remain accessible
during normal use. In order to disconnect the radio from the mains
completely, the mains plug should be removed from the mains
outlet completely.
Operating your radio FM
. Connect the Antenna
The radio comes with built-in AM/FM antenna. To improve FM
reception, insert the end of the supplied FM wire antenna into the
F-type antenna terminal and adjust the wire for best reception. A
75 ohm coaxial cable of outdoor antenna may also be attached
to the terminal. Be sure to switch external/internal antenna switch
to external position while using the supplied wire antenna or connect
the outdoor antenna. In some of the European countries, you may
have to connect the supplied antenna terminal adaptor to connect
with the outdoor antenna.
. Turn on your radio by switching the Power knob to volume position.
Then rotate the Band selecting rotary to FM position.
3. Rotate the Tuning Control to select the desired station. On FM,
the tuning scale is marked in MHz (Megahertz). The tuning LED
indicator will appear brightest when best tuning has been achieved.
4. Adjust the Volume Control for comfortable listening.
5. To switch off the radio, turn the Power knob to OFF position.