Assembly – Feiyue FM206 User Manual
Page 6
ASSEMBLY
‐
Insert handle in the body. Secure handle with provided screw.
‐
Insert head to the body and secure head with provided screw.
‐
Securely fasten washable microfiber pad on the head by pulling the cord & pressing the toggle.
‐
If using the Family Steam Mop FM206 on carpets, place mop head with pad over Carpet Glider.
‐
To remove water reservoir, pull reservoir up and detach unit from body as shown.
‐
Using provided cup to fill reservoir. Maximum capacity of 800 ml. Do not overfill reservoir.
‐
It is recommended that this appliance not used in conjunction with other high wattage
appliance on the same circuit to avoid a circuit overload.
‐
Slowly pass over surface to clean. It is recommended to sweep/ vacuum surface prior to steam.
‐
To sanitize a surface, leave the Family Steam Mop over the area for a minimum of 8 secs but not
longer than 15 seconds to avoid possible damage to the surface. (Results may very)
‐
Never run the Family Steam Mop FM206 without water and never direct steam at any person or
animal. Use the Steam Mop only on sealed floor only. When you finish using the item, shut off,
turn off and unplug the unit. Allow it to cool down before storing the steam mop.