Warpia SWP220 - Manual (Page 37)

Wireless USB DisplayDock Set User Guide
Page 37
Problem/Question Symptoms Solution
Channel busy message
displays when I try to
change the channel
Note: manual channel
selection may be restricted
by local communication
regulation laws. External radio interference may exist close to the
PC/device
Channel selection SW may have failed
Another wireless system may be in use
in proximity to the PC or device
environment, and may cause temporary
interference to the wireless USB
system. Try to select a different
channel (where applicable - local
regulatory restrictions may apply)
Close the message box, detach the PC
Adapter from your PC and re-attach it.
If the message displays again, try to
change the channel again.
Problems with Pairing
see also - Appendix B:
Pairing Procedure
The Pairing procedure does not result in the
confirmation screen "WIRELESS USB device has
been paired", or results in an error message. Detach and re-attach Device Adapter
OR
Re-attach PC Adapter, then attach
Device Adapter
OR
Detach all Adapters, restart PC and try
Pairing again
Pairing with multiple Hosts
present – each pairing must
correspond to a specific PC
Adapter (Host)
see also - Appendix B:
Pairing Procedure
If more than a single PC Adapter (Host) has been
attached to the PC at any time, the pairing process
requires that at least one PC Adapter be connected
while the Device Adapter is being paired Ensure that a single PC Adapter is
attached to the PC, and then re-attach
the Device Adapter to perform Pairing