C. Crane SEAK - Manual (Page 2)

WiFi Hotspot Repeater Quick Start Guide WiFi Hotspot Repeater Quick Start Guide
J
Now you will choose an easy name to call your new WiFi
Network. (Example: “BobsNetwork”). Enter it into the
“SSID Choice” field. Do not use the same name as the network
you are repeating.
If you cannot access the Setup Screen then you may need to
perform a factory reset. To do this, press the red button on the
bottom for at least 5 seconds while it is powered ON. You may
need to use a toothpick or paperclip to reach it. Allow 30 seconds
for the hotspot to reset and startup before attempting setup again.
Reset Button
Bottom Panel
TROUBLESHOOTING
3
Click on “Site Survey”.
G
Scroll towards the bottom of the page. 1. Click the dot
next to the WiFi Network that you want to repeat, then
2. Click “Select”.
H
2
I
1. If your selected Network requires a password, then enter
it into the space marked “Pass Phrase”
* . Do not change
any other settings. 2. Click on the “Next” button.
1
4
*
If the security mode is WEP, then enter password into
“WEP Key 1”.
1
Congratulations, your new Network is ready to use !
Connect to it from the WiFi Network list on your device.
Look for the name that you entered in step
J
and enter the Password that you entered in step
K
1. Choose “WPA-PSK_WPA2-PSK” from the “Security Mode”
dropdown. 2. Choose “Auto (TKIP/AES)” 3. Now create a
wireless password and enter it into the “Pass Phrase” field.
You must choose a password that contains between 8 and 64
characters. 4. Click on the “Done” button to finish the setup.
K
1
3
4
2
2
Copyright ©2015 C. Crane All Rights Reserved