CANOGA PERKINS 6008 Wave Division Multiplexer - Manual (Page 3)

Canoga Perkins Corporation, 20600 Prairie Street, Chatsworth, CA 91311-6008
Phone: (818) 718-6300, FAX (818) 718-6312 www.canoga.com
P/N 6912373 Rev D
Overview
This document provides steps necessary to install and configure Canoga
Perkins’ passive CWDM products correctly. The passive CWDMs come in
variations of 4, 5, 8 and 9 channels. The 4 and 5 channel versions occupy one
slot in the UCS 1000, UCS 1001 and UCS 1050 chassis while the 8 and 9
channel versions occupy two slots in the UCS 1000 chassis only. All
connections are made from the front of the units and the optical ports are marked
“Tx” for transmit and “Rx” for receive.
Installation
Ensure that there is no visible damage to the CWDM module. Insert the CWDM
module into any slot in the chassis. See figures 1 through 3.
Figure 1
Model 6008 installed in UCS 1000 with 8 active transponders
Figure 2
Model 6004 installed in UCS 1001