CANOGA PERKINS 1500 Domain Management Module - Manual (Page 30)

EdgeAccess Universal Chassis System
SYSTEM LOG
Description Type Username Local Date/Time
Ch1 Online
Trap SYSTEM * 11-Mar-2004 08:53:56.02
Module Inserted in Ch 1, Sl 7
Trap SYSTEM * 11-Mar-2004 08:53:56.12
Module Inserted in Ch 1, Sl 8
Trap SYSTEM * 11-Mar-2004 08:53:56.22
Module Inserted in Ch 1, Sl 10
Trap SYSTEM * 11-Mar-2004 08:53:56.32
Module Inserted in Ch 1, Sl 14
Trap SYSTEM * 11-Mar-2004 08:53:57.42
Module Inserted in Ch 1, Sl 15
Trap SYSTEM * 11-Mar-2004 08:53:57.52
user logged in
Security admin * 11-Mar-2004 08:56:43.32
user logged in
Security admin * 11-Mar-2004 09:54:32.22
Figure 5. Typical System Log Screen
Set Up the Syslog Client
You can direct messages and information from the System Log to up to two servers set up to
receive messages according to the BSD Syslog Protocol. Canoga Perkins uses the lowest five of
the eight available message severity levels; see Table 8. To set up the Syslog Client, follow these
steps:
1. From the Domain Management Module menu, type 11 , "SYSLOG Configuration," and press
<Enter>.
2. At the SYSLOG Configuration screen, type the number for a Syslog Server and press
<Enter>, then follow the prompts on the screen to enter the values for a primary or alternate
server:
• IP Address: Set the address for the server; 0.0.0.0 indicates no server
• Port: Set your server's port; default is 514
• Mask: Set the minimum level of severity for messages; see Table 8
3. To return to the System Configuration menu, press <Esc>.
3-18 Model 1500 Domain Management Module