CANOGA PERKINS 1502 Domain Management Module - Manual (Page 16)

EdgeAccess Universal Chassis System
Model 1502 Domain Management Module 3-6
Table 3. Domain Management Module Menu Selections
Menu Item Description
1. System Configuration Set values for the system information and communications
parameters
2. Change Security & Passwords Set up system security and access
3. Ping Generation Send a PING from the DMM to a specific IP address
4. Software Upgrade Download and install new firmware
5. Trap Configuration Set the DMM conditions that generate SNMP traps
6. Host Table Set up managing hosts for accessing the DMM and
receiving traps
7. Trap Destination Table Set up notification by destination
8. Modem/SLIP/PPP Configuration Set up the serial communication port
9. Set Date and Time Set date and time for the DMM; this information is passed
to each module in the domain
10. SNTP Configuration Set up SNTP parameters.
Configure the DMM for the System
To set values for basic system parameters, including some SNMP parameters, as well as view
basic system information, go to the System Configuration report and menu. See Tables 4 and 5.
To access the System Configuration screen, follow these steps:
1. At the Domain Management Module menu, type 1 , "System Configuration," and press
<Enter>. The System Configuration screen appears.
2. At the prompt, type an item number and follow the prompts on the screen. To change a
password, you must know the current password.
3. To return to the Domain Management Module menu, press <Esc>.
Table 4. System Configuration Report
Item Description
Chassis Type Always 2U, the UCS 1002
Ethernet Address MAC address for the DMM
Ethernet Link Shows link status (up or down) and current full or half-duplex
Current Bootcode Version number for bootcode for this module
Current Firmware Version number for firmware for this module
Active Bank Flash memory that holds the currently-used firmware