CANOGA PERKINS L351 10/100BASE Media Converter - Manual (Page 57)

EdgeAccess Universal Chassis System
L351 10/100BASE Media Converter 4-33
Figure 4-28. Latency/Jitter Test Screen
4.6.2 Remote Connectivity Loss Detection
The Connectivity Loss Detection (CLD) feature enables you to detect loss of connectivity between
two N525s in a point-to-point circuit, and to detect undesired link performance. It is possible to
remotely configure N525 CLD parameters using the SideBand management channel from an L351.
See the diagram below.
Figure 4-29. N525 to N525 Connectivity Loss Detection
In conjunction with CLD you can use Connection Loss Forwarding (CLF), which will shut down the
User port on an N525 if there is a loss of connectivity between the N525 Extension ports. CLD and
CLF are disabled by default.
POP A
SNMP Fibre
N525 L351
In UCS1002
POP Z
Fibre
N525
Customer
Premise Z
L351
In UCS1002
SNMP
---------------------------REMOTE LATENCY/JITTER TEST-----------------
Test IP Addr/VLAN 0.0.0.0/0 Round Trip Packets 0
Test Duration 00:00 Dropped Packets 0
Minimum Latency (ms) 0.000000 Minimum Jitter (ms) 0.000000
Average Latency (ms) 0.000000 Average Jitter (ms) 0.000000
Maximum Latency (ms) 0.000000 Maximum Jitter (ms) 0.000000
(1) To IP Addr 0.0.0.0 (5) DF Bit Clear
(2) From IP Addr Auto Selection (6) DSCP Precedence Best Effort
(3) Test VLAN 0 Drop Probability Not Used
(4) Test Packets per sec 1 (7) Test Packet Priority (0-7) 0
(8) Test Duration min:sec (0=forever) 0
(9) Min Test Payload Size (40 - 1954) 40
(10) Max Test Payload Size (40 - 1954) 40
(11) Test Packet Timeout sec (1 - 10) 3
(12) Start Remote Test
(13) Stop Remote Test
Select [1-13]:
-------------------------------Messages-------------------------------