Citronic CM-LIVE - Manual (Page 2)

CM-LIVE and CM-STUDIO Mixers User Manual
Caution: Please read this manual carefully before operating
Damage caused by misuse is not covered by the warranty
Introduction:
Thank you for choosing a Citronic CM series mixer. This product has been designed to offer reliable, high
quality mixing for stage and/or studio applications with unfailing consistency. In order to gain the best results
from this equipment and avoid damage through misuse, please read and follow these instructions and retain
for future reference.
Warning:
To prevent the risk of fire or electric shock, do not expose any of the components to rain or moisture.
If liquids are spilled on the surface, stop using immediately, allow unit to dry out and have checked by
qualified personnel before further use.
Avoid impact, extreme pressure or heavy vibration to the unit.
There are no user serviceable parts inside the mixer – refer all servicing to qualified service personnel.
Safety
 Check that the supplied adapter and connectors are in good condition and the mains supply voltage is
correct.
 Ensure signal leads are of good condition without shorted connections (especially when using phantom
power)
 Do not use the USB connector as a general purpose power source or charger.
 Do not allow any foreign particles to enter the console through connectors or control apertures
Placement
 Keep out of direct sunlight and away from heat sources.
 Keep away from damp or dusty environments.
 When rack-mounting, (CM8-LIVE, CM10-LIVE, CM8-STUDIO) use rack ears supplied, securing firmly.
 Ensure adequate access to controls and connections, including USB/SD player on rear panel (CM-LIVE)
Cleaning
 Use a soft cloth with a neutral detergent to clean the casing as required
 Use a soft brush to clear debris from the control surface
 Do not use strong solvents for cleaning the unit.