Dynon Avionics EFIS-D60 Pilots Users Guide - Manual (Page 32)

Appendix
7-4 EFIS-D60 Pilot’s User Guide
Alert Message Description End condition
REMOTE COMPASS
NOT DETECTED The EFIS-D60 is unable to communicate with the
EDC-D10A. If you have an OAT connected to
your EDC-D10A, you will lose this reading, as
well. Ensure that you a) have an EDC-D10A installed
and b) have verified that the wiring to the EDC-
D10A is correct. Please see the EFIS-D60
Installation Guide for more information on
verifying the installation of the EDC-D10A.
This error also can appear if you have updated
the firmware in your EFIS-D60 while the
remote compass was not connected. If this is the
case, try uploading the new firmware again with
the EDC-D10A connected. Attempt the
connection within the first few seconds of
operation.
Note that the EFIS-D60 does not have internal
magnetic sensors and thus requires the EDC-
D10A be connected.