Dynon Avionics EFIS-D10A Pilots Users Guide - Manual (Page 19)

Product Operation
Changing the Screen Rotation
You may use the out-of-the-box screen rotation or define your own. If you desire to use the initial rotation, no user
configuration is required. If you desire to use a custom cycling order, then user configuration is necessary.
To configure a custom rotation, navigate to the SCREEN LIST menu
page by pressing button six for approximately two seconds when no
menu is present. Press SETUP, then press ROTATN to display the menu
used to change the boot and rotation screen. Scroll through the pre-
defined screens using the DOWN▼/UP▲ buttons.
Press the BOOT* button on any selected screen configuration to make it
the screen that is shown immediately after the instrument is turned on.
Only one screen may be designated as the boot screen. Next, press the
TOGGL↕ button on any selected screen to toggle the “↕” icon. All
screens that show the “↕” icon are included in the rotation. Any screen in
the rotation may be accessed via the button one and six hotkeys. Press
BACK to save any settings.
cycles to
prev.
screen
cycles to
next
screen
Changing the Screen List Order
You may wish to change the order in which screen configurations are
displayed in the SCREEN LIST, thus changing the order they are cycled
to via hotkeys. To do this, navigate to the SCREEN LIST menu page by
pressing button six for approximately two seconds when no menu is present. Press SETUP, then press ORDER to
display the menu used to change the screen order. Scroll through the pre-defined screens using the DOWN▼/UP▲
buttons. Press the MV DN▼ button to move the selected screen down in the screen list. Likewise, press the MV UP▲
button to move the selected screen up in the screen list. Buttons one and six cycle to the previous
and next screens, respectively.
EFIS-D10A Pilot’s User Guide 3-5