Dynon Avionics EFIS-D10A Installation Guide - Manual (Page 84)

Appendix
Universal Conn
T llo ctions that must be ma
installation. These required connections ensure that the HS34 can power on, communicate with
other Dynon products, connect to a laptop for firmware uploads, and output audio alerts to your
eme
.
ections
he fo wing diagram shows the wiring conne de in every HS34
intercom system. Once properly configured on your DSAB network, this connection sch
allows you to use your HS34’s VALUE knob with the DSAB Bus Master. Refer to the Dynon
Smart Avionics Bus (DSAB) Wiring section on page 3-11 for more information on connecting
Dynon products via DSAB. Refer to the DSAB Configuration section on page 5-1 to review the
concepts involved in a networked system as well as an example system which includes an HS34
Again, the “Male D25” in the diagram below refers to the male connector on the back of the
HS34. The harness you construct to make these connections will terminate in a female D25
connector.
7-12 EFIS-D10A Installation Guide