Lec L50262W - Manual (Page 6)

EN - 5 -
Installation and Switching On The Appliance
• This appliance is connecting to 220-240V or 200-230V and 50 Hz. Please check
nameneplate of appliance and be sure voltage range suitable to your mains voltage.
• Before making the connection to the power supply, ensure that the voltage on the
nameplate corresponds to the voltage of electrical system in your home.
• Insert the plug into a socket with an efficient ground connection. If the socket has no
ground contact or the plug does not match, we suggest you to call an authorised
electrician for assistance.
• The plug should be accessible after the appliance is positioned.
• Manufacturer is not responsible for failure to complete the
ground connection as described in this booklet.
• Do not place the appliance in direct sunlight.
• Do not use in open air and shall not be exposed to the rain.
• Place the refrigerator far from heat sources and in a well-
ventilated position. The refrigerator should be at least 50 cm
from radiators,gas or coal stoves and 5 cm far from electrical
stoves.
• Keep the top free for at least 15 cm.
• Do not place heavy and lots of things on the appliance.
• If the appliance is installed next to another refrigerator or freezer,
observe a miminum distance of 2 cm to prevent condensation.
• Do not put very ( !) hot food or bowl on the top table.It can damage
the toptable.
• Fit the plastic wall spacers to the condenser at the back of the
refrigerator in order to prevent leaning to the wall for good
performance.
• The appliance must be stand firmly and level on the floor Use
levelling-feet to compensate for an even floor.
• The outside of the appliance and the accessories inside should be cleaned with a
solution of water and liquid soap ; the inside of the appliance with sodium bicarbonate
dissolved in lukewarm water. After drying replace all the accessories.
Before Switching On
• Wait after 3 hours before plugging the appliance in to the power to
ensure proper performance.
• There can be an odor when you first switch on the appliance. It will
disappear after the appliance starts to cool.
Warning: Do not damage the refrigerant circuit.
Warning: Do not store explosive substances such as aerosol cans with a flammable
propellant in this appliance.