Lec U5010W - Manual (Page 14)

The wires in the mains lead
are coloured in accordance
with the following code:
Green and Yellow = Earth
Blue = Neutral
Brown = Live
Changing the Plug
11
Any electrical work required to install this appliance should be
carried out by a qualified electrician or competent person.
This appliance must be earthed. The manufacturer declines
any liability should these safety measures not be observed.
Electrical Requirements
Before switching on, make sure the electricity supply
voltage is the same as that indicated on the appliance
rating plate. The appliance is supplied with a 13 amp plug fit-
ted. In the event of having to change the fuse in the plug
supplied, a 13 amp ASTA approved (BS 1362) fuse must be
used. Should the plug need to be replaced for any reason. The
wires in the mains lead are coloured in accordance with the
following code:
Green and Yellow: Earth
Blue: Neutral
Brown: Live
The wire coloured green and yellow must be connected to the
terminal marked with the letter "E" or by the earth symbol *
or coloured green and yellow. The wire coloured blue must be
connected to the terminal "N". The wire coloured brown must
be connected to the terminal marked "L".
Upon completion there must be no cut, or stray strands of wire
present and the cord clamp must be secure over the outer
sheath.
Important!
The plug must still be accessible after the appliance has been
installed. The appliance should not be connected to the
electrical supply by means of an extension cable. In case that
the electrical cable has to be replaced, please contact the
Customer Care Centre and arrange a service engineers visit.
Warning!
A cut off plug inserted into a 13 amp socket is a serious safety
(shock) hazard. Ensure that it is disposed of safely.
This appliance complies with the following E.E.C. Directives:
73/23 EEC of 19.02.73 (Low Voltage Directive) and subsequent
modifications, 89/336 EEC of 03.05.89 (Electromagnetic
Compatibility Directive) and subsequent modifications.