Lec BC9097ST User Manual

Page 4

Advertising
background image

DEFROSTING

The

Bottle

Cooler

has

an

automatic defrost system that

requires no special operations on

the part of the user. The on / off

cooling cycles of the appliance

are specifically designed to allow

for

defrost

during

normal

operation.

Note:- Clean and dry thoroughly

before switching “ON” (as in

“Cleaning your Appliance”)

INTERNAL LIGHT

The coolers are fitted with

internal fluorescent lights that

can be switched on and off using

the switch located at the bottom

of the cabinet. The light should

be turned off whenever it is not

required, in order to save energy.

Should the light bulb need

replacing first turn off the power

supply and remove the plug from

the socket.

The light cover is made from

flexible

polycarbonate.

To

remove it, starting at one end,

gently free it from the bottom

flange towards the rear of the

cabinet

and

then

pull

it

downwards.

The starter for the light is located

to the left of the light bulb and if

necessary may be removed by

giving it a ¼ turn and pulling it

from its socket.

The light bulb is rotated ¼ turn to

align the connector pins and then

moved carefully to free it from its

sockets. Replace the bulb with an

equivalent 8Watt or 15Watt (or in

some cases 4W) bulb and rotate it

¼ turn to lock it in position.

Locate the cover into the recess

of the light housing and feed its’

edge into place in the bottom

flange.

Plug in and restart the appliance.

CLEANING YOUR APPLIANCE

Your appliance is easy to keep

clean.

Regular

cleaning

is

important for health reasons.
Exterior:

Use a good wax polish that will

clean and polish the cabinet in

one easy application. DO NOT use

an aerosol polish as the spray

may damage plastic parts.
Interior:

Before using for the first time,

and when required, the interior of

your appliance should be wiped

with a soft cloth dampened with a

solution of one teaspoonful of

Bicarbonate of soda to one litre

of warm water. Rinse with clean

warm water, and dry thoroughly.
DO NOT use soaps, wire wool,

scouring powder or disinfectants

of any kind.
Periodically clean the gasket to

prevent a build up of beer and

sugar liquids.

USEFUL HINTS

If your appliance is to be out of

service for any length of time

ensure that the interior is

thoroughly cleaned and dried.

Leave the door open and

disconnect the plug from the

mains supply.
Carry out cleaning according to

instructions.

See that vibration noises are not

caused by the cabinet being on

an uneven surface. Adjust the

levelling foot.

SAFETY NOTES

If you are disposing of an old

cabinet, break off any latches and

remove doors, dispose of the

doors separately and safely.
DO ensure that the appliance is

earthed
DO ensure that the appliance is

disconnected from the mains

supply before attempting to

remove the light cover.
DO NOT store flammable or

explosive substances in the

cabinet.
Should the mains lead to this

appliance be changed for any

reason, it must be replaced by a

special lead (Part No. E 2622)

obtained from the address on the

back page of the instructions.

6

5

Advertising
This manual is related to the following products: