Leica Geosystems Leica DISTO Classic3 User Manual
Disto, Classic, User manual
Advertising
Table of contents
Document Outline
- Contents
- Open Instrument
- Insert Batteries
- Display
- Keypad
- ON Key and Measurement Key
- Measuring
- Continuous measurement (Tracking)
- Laser in continuous operation
- Plus/Minus Key
- Quick switching off
- In roll mode
- Partial heights, chain values
- Multiplication Key
- Area
- Volume
- Time delay release
- Equal Key
- Doubling a measured value
- Setting Key
- Settings in roll mode
- Setting reference only for one measurement
- Set desired reference to "Permanent"
- Measure with additional tolerance
- Unit - metre / feet / feet inch
- "Beep" during operation
- Resetting
- Function Key
- Recall last measured value (stack)
- Saving a constant (Fnc 1)
- Recalling the constant
- Continuous measurement (Tracking) Maximum (Fnc 2)
- Continuous measurement (Tracking) Minimum (Fnc 3)
- Pythagoras, height measurement
- User Information
- Range
- Rough Surfaces
- Transparent Surfaces
- Wet, Smooth or High-Gloss Surfaces
- Illumination
- Environment
- Free-handed aiming
- Inclined, Round Surfaces
- In the field
- Accessories
- Telescopic viewer (667478)
- Wrist strap (667491)
- Shoulder strap (563 879)
- Carrying pouch (667 169)
- Level (667 158)
- Target plate (563875)
- Holster (667489)
- Software
- Safety Instructions
- Use of the Instrument
- Permitted use
- Prohibited uses
- Limits to use
- Areas of Responsibility
- Hazards in Use
- Laser Classification
- Labelling
- DISTO with Telescopic Viewfinder
- Electromagnetic Compatibility
- Care and Storage
- Care
- Storage
- Transport
- Despatch
- Message Codes
- Technical Data
- Remarks on Measuring Accuracy
- Set Mark for Viewfinder
- Accuracy Tests