Leica Geosystems Leica DISTO DXT - Manual (Page 11)

10 Appendix Leica DISTO™ DXT 776113
GB
D
N
S
FIN
DK
SLO
TR
GR
ROK
RUS
SK
CZ
H
PL
EST
LT
LV
BG
RO
Historical memory
1x briefly: the symbol and the last measured
value are displayed.
Use the "+" or "-" buttons to navigate through the
last 10 values. A long key press allows the values to
be used in other functions.
Switching off the beep
Press and hold simultaneously for 3 seconds:
The beep is switched off.
To reactivate it, press and hold for 3 seconds.
Appendix
Display Notices
All display notices are either displayed with or
"Error". The following errors can be corrected.
Cause Correction
204 Calculation error Repeat procedure
252 Temperature too
high Let device cool down.
253 Temperature too
low Warm device up
255 Received signal too
weak, time for a
measurement too
long. Use a target plate
256 Received signal too
strong Use target plate (gray
side)
257 Faulty measure-
ment, too much
background light Use target plate (brown
side)
258 Outside of the range
of measurement Select measurement
distance within the
range of measurement
Error Cause Correction
Error Hardware error Should this message
remain active after
switching the instru-
ment off and on several
times, please contact
your dealer.