Leica Geosystems Leica DISTO lite5 - Manual (Page 12)

12 Technical Data DISTO lite 5 1.2.0 en
de
en
fr
it
es
pt
nl
da
sv
no
fi
jp
zh
ko
pl
hr
hu
ru
cz
el
Technical Data
All rights reserved to make technical changes.
*
Display unit as off 100m : 1 cm
** At long range ± 5 ppm (± 0,5mm/ 100 m) plus short
range error.
Message Codes
Error message
appears beside the message number on the
display.
In case of this message switch on/off instrument
several times and check if message is still
displayed. Then call service and specify the
message displayed.
Care
Look after the optical surfaces with the same care that you
would apply to spectacles, cameras and field glasses.
Measuring accuracy
(2x standard deviation)
typ.: ± 3mm / max.: ± 5mm
Smallest unit displayed 1mm
Range 0.2m up to 200m * **
Time for a measurement dist / trc 0.5...ca.4s / 0.16...ca.1s
∅ Laser spot (at distance) 6 / 30 / 60 mm (10 / 50 / 100 m)
Illumination 
Multiline display 
Aiming aid 
Time delay release 
Battery, Type AA, 2x 1.5V up to 10’000 measurements
(only with Alkaline batteries!)
Splash and dust
proof
IP54 acc. IEC529: splash proof,
dust proof
Dimension and weight 142 x 73 x 45 mm, 315g
Measuring accuracy of bubble 1°
Temperature range
Storage
Operating
-25°C to +70°C
(-13°F to +158°F)
-10°C to +50°C
(-14°F to +122°F)
Message
Code
Cause Remedy
204 Calculation error Repeat procedure
252 Temperature too high,
above 50°C (measuring)
Cool down instrument
253 Temperature too low,
below -10°C (measuring)
Warm up instrument
255 Receiver signal too weak,
measurement time too
long, distance <200 mm
Use target plate
measurement time >10
sec.
256 Received signal too
powerful
Use target plate (correct
side)
257 Wrong measurement,
ambient brightness too
high
Use target plate
260 Laser beam interrupted Repeat measurement
All other messages Call service "System"