Cabletron Systems 1088 - Manual (Page 62)

M o d e l i n g P r e p a r a t i o n f o r M o d e l i n g
S p e c t r u m E n t e r p r i s e M a n a g e r Page 63 S m a r t S w i t c h 6 0 0 0
Figure 18: Chassis Container View Preparation for Modeling
Before modeling the chassis, you should be
familiar with the process of creating models and
accessing views. Refer to Getting Started with
SPECTRUM for Administrators and How to
Manage Your Network with SPECTRUM for
instructions. You should also be familiar with any
network management and firmware requirements
described in the 6C105 chassis firmware
documentation.
Modeling Using the Chassis IP
The chassis model can only be place in a Room
Location view. The Room Location view is created
by starting at the Universe level view and navigate
into the Room Location level, as described below.
1 At the Universe level, select View > New View
> Location.
This places you at the top level of the Location
views.
* File View Help
Primary Landscape 0x00400000 - VNM Host -
Model One
6E122_26
Model Two
6E138_25
Model Three
6E233_49
Model Four
6H202_24
Model Five
6H122_16
Caution: Caution:
For proper modeling, the chassis and its
installed modules must not be in Mixed
Management mode. Each module should
have its own IP address or the chassis
should be configured with a single IP
address.