Leica Geosystems Leica DISTO A3 - Manual (Page 7)

4 Appendix Leica DISTO™ A3 1.1.0 gb
D
GB
F
I
E
P
NL
DK
S
N
FIN
J
CN
RC
ROK
PL
H
RUS
CZ
Areas and volumes can be added / subtracted in
exactly the same manner.
Area
Press AREA/VOLUME - key {A, 3}. The corresponding
symbol { B, 5} appears in the display. The first side to
be measured flashes on the display. Take the two
measurements, the result will be displayed in the
main line.
Volume
Press AREA/VOLUME - key {A, 3} twice. The corre-
sponding symbol { B, 5} appears in the display. The
first distance to be measured flashes on the display.
When 3 measurements have been taken the result
will be displayed in the main line.
Historical storage
Pressing the STORAGE - key {A, 7} shows the last 19
displays in reverse order. Using the PLUS - key {A, 2}
and the MINUS - key {A, 8} allows to navigate in the
storage .
In order to leave the storage press either CLEAR - key
{ A, 5}, DIST - key {A, 1} or the AREA/VOLUME - key
{ A, 3}. Press and hold the STORAGE - key {A, 7} until
a beep, allows the user to take the selected result to
carry on with calculations.
Appendix
Message Codes
All message codes will be displayed with either "InFo"
or "Error".
The following mistakes can be corrected:
InFo Cause Remedy
204 Calculation error Repeat procedure
252 Temperature too
high Cool down instrument
253 Temperatur too low Warm up instrument
255 Receiver signal too
weak, measurement
time too long, Use target plate
256 Received signal too
powerful Use target plate
(grey side)
257 Wrong measure-
ment, ambient
brightness too high Use target plate
(brown side)
260 Laser beam inter-
rupted Repeat measurement
Error Cause Remedy
Hardware error Switch on/off the
device several times
and check if the
symbol still appears. If
so please call your
dealer for assistance.