Panasonic WV-7230D - Manual (Page 8)

C. Wiring with the Connection Cable (WV-CA50)
The appearance and cord length is shown in the drawing.
The parts name of WV-CA50 is shown in the following.
No. Parts name
1 18 wires cable
2 14P housing
3 12P housing
4 10P housing
5 8P housing
6 Contact
7 BNC connector
The wire gauge can be determined by the chart below.
• The system should be operated by 24V AC and the
power consumption should have less than 11W for the
camera.
Model WV-7230D
Copper wire gauge AWG No. Cable length
AWG size
Impedance
(fì/km)
11 13
#24 77.9 ft 30 65
m 10 15
#22 50.4 ft 50 100
m 15 30
#20 32.3 ft 80 155
m 20 45
#18 19.9 ft 130 250
m 40 70
• Cable assembly:
Strip back the cable jacket approx. 0.1 inch and
separate the individual conductors.
D. In case of using the accessory connectors
(MX5557P08 and MX5S57P10)
Select a multi-conductor cable which meets FR-1 rating
with 11 or 13 wires cables for WV-7230D.
12 wires cable is used to extend the cable lengt^
Connect the 11 or 13 wires cable to the following positions
of the accessory connectora
CN Pin No.
WV-7230D
Usage of Terminal Power Source
CN1-1 LEFT 24 V AC
CN1-2 RIGHT
CN1-3 UP
CN1-4 Down
CN2-1 24V AC Camera
CN2-5{6)(7) AC Common
CN1-7 DC COMMON 24V AC Common
CN1-8 Iris Control ±6V DC Common
CN1-9 Focus Control ±6V DC
CN1-10 Zoom Control
CN2-8 Camera Ground
• If 13 wires cable are available for WV-7230D, connect
the remainded 2 wires to the ( ) positioa
1 1
10 9 £ П 7 6
5 4 ; П 2 1
8 7 6 5
4 3 2 1
CN1 CNZ
The accessory connectors view from wiring side.
Contact
Up >
^^3
Approx.
0.1 inch
Wire
2
^ Insert
Insert the wire until A position
and clamp the contacts.
Preparate the individual cortductors for clamping.
If clamping, use MOLEX brand tool part number
57027-5000 (for UL-Style Cable UL1015 or
57026-5000 (for UL-Style cable UL1007).
After clamping the contacts, push them into the proper
holes in the connector housing until they snap in place.
Up
Î
Wire
Contact
CAUTIONS:
Shrinking the cable-entry seal is a one-time procedure.
DO NOT shrink the cable-entry seal until it has been
ascertained that the unit is functioning.
CONNECT THIS TO 24V AC CLASS 2 POWER SUPPLY
ONLY.
Caution: To prevent fire or shock hazard,
the UL listed wire VW-1, style 1007
should be used for the cable for 24V
AC Input Terminals.
-
7
-