Panasonic PV-M1367AD - Manual (Page 6)

Antenna or Cable Connections
Outdoor Antenna Connection
Unhook the antenna from your previous TV
or VCR and connect it to the back of the
Combination VCR as shown in the diagram.
If your antenna system has separate UHF
and VHF lead-ins, you need a UHF/VHF
Band Mixer (not supplied).
(Flat)Twin Lead
300 Ohm Cable
(Round) 75 Ohm
coaxial Cable ^
300-75 ohm
from Transformer
Antenna (supplied)
UHFA/HF
Band Mixer
(not supplied)
(Flat)Twin Lead
300 Ohm Cable
Back of
Combination VCR
Indoor Antenna Connection
Insert the Indoor antenna (supplied) into the
receptacle on the back of the Combination
VCR.
Then, connect the two wires to the 300
ohm-75 ohm transformer (supplied).
Next, connect the transformer to the back of
the Combination VCR as shown.
Now, extend the antenna and adjust its length,
direction and angle for the clearest picture.
Cable Connections
(A) Without a Converter/Descrambler Box
With this connection, you can; use your
Combination VCR remote control to select
channels for viewing and select unscrambled
channels for timer recording. Scrambled
channels mav not be viewed or recorded with
this connection.
(B) With a Converter/Descrambler Box
With this connection, you may record and view
any channel including scrambled channels.
Please note, however that channel selection
must be made at the cable company converter
box. Timer recording is limited to one channel
at a time, and you can only view the channel
you are recording.
(A)
Back of Combination VCR
(B)
(cable)
To Watch and Record Scrambled/
Unscrambled Channels
Set the Combination VCR to the output channel
of the cable converter box (e.g. CH3).
Now, select channels to be viewed or recorded
at the cable converter box.
FCC WARNING: Any unauthorized changes or
modifications to this equipment would void the
user’s authority to operate.
Note to CATV System Installer
This reminder is provided to call the CATV (Cable TV)
System Installers attention to Article 820-40 of the
NEC that provides guidelines for proper grounding
and, in particular, specifies that the cable ground shall
be connected to the grounding system of the building,
as close to the point of cable entry as practical.