Panasonic NV-J45 Series - Manual (Page 26)

Timer Recording (Confd)
9
10
Press the Next Button.
Press the Number Buttons to select the hour of the
end time of the TV programme.
t j
$
3
SP
ON
t U L \ t \ i J L
/nO----------
11 Press the Next Button.
12 Press the Number Buttons to select the minute of the
end time of the TV programme.
S' 3
D
SP
ON
I *UC i
------
13 Press the Transmit Button.
»The tape speed (SP/LP) can be selected In any of
the steps 1 to 12.
• When transmitting the programmed data to the VTR
without selecting the desired tape speed (SP or LP
is not lit in the Display), the tape speed indicated in
the Multi Function Display on the VTR will be
programmed for the timer recording.
• To immediately programme one more timer
recording, press the Programme Button two times
after transmitting the programming data of the first
timer recording to the VTR. Then programme the
second timer recording.
■ If no operation is performed on the Remote
Controller for more than 25 seconds, it will
automatically switch over to the power-saving
standby condition and the indications on the Display
will disappear. In this case, the data which have not
yet been transmitted to the VTR will be cancelled.
Transmit the Programming Data
Keep pressing the Transmit Button and confirm that the
programmed data on the Multi-Function Display of the
VTR are as desired.
After releasing the button, the data will continue to be
displayed for about 12 seconds.
• If the transmission was not received correctly, the
“Beep-Beep, Beep-Beep’’ sound from the VTR will warn
you. In this case, perform transmission again.
• The transmission is possible when the VTR is turned on
but is not in any of the recording or playback operation
modes. It is also possible when the VTR is in the timer
recording standby mode (H indication is lit).
• The programming will be done on the next lower
unoccupied timer programme number (8-1).
• If all programme numbers are occupied, the
“Beep-Beep, Beep-Beep” sound from the VTR will warn
you that the programming cannot be made.
• When the Transmit Button is pressed, the VTR will
automatically be put into the timer recording standby
condition and the VTR will be turned off.
• To operate the VTR before the timer recording will be
performed, press the Timer Record Button to suspend
the timer recording standby condition. After using the
VTR, be sure to press the Timer Record Button again,
otherwise the timer recording will not be made.
For Recording via External Input
For Example:
Programming a timer recording via Video Input Socket and
Audio Input Socket on the 3rd of the month, from 7:02 to
7:30.
Perform the operation step 1 on page 25.
2
Press the Input Signal Selector. The “A1” Indication is
lit.
Perform the operation steps 3 to 13.
For Everyweek Recording
For Example:
Programming a timer recording for a TV programme that
is broadcast every week on Sunday, from 7:02 to 7:30.
Perform the operation steps 1 to 3 on page 25.
4
Press the “9” Button and then the “1” Button within
5 seconds. The “SU” Indication {=Sunday) is lit.
i s \ i )
ON
SP
OFF
Perform the operation steps 5 to 13.
(
26
)