Panasonic KX-T7885 - Manual (Page 7)

G
etting
S
tarted
[ L ocation of C ontrols and C onnection for the B ase U nit ]
^ Base Unit
Q Connect as shown,
13 Raise the antenna.
Locator key:
Used to locate the
handset.
DIALING MODE Selector:—
When in the SLT mode,
setting is necessary.
If your telephone line has touch
tone service, set to “TONE".
If it has rotary service, set to
“PULSE".
Fasten the AC adaptor
cord to the cord holder.
To AC Outlet
(120VAC, 60Hz)
CONNECTION MODE
Selector:
If connected to a Telephone Line Jack or
a PBX, except for Panasonic KX-T,
KX-TA or KX-TD series, set to “SLT”.
If this unit is connected to Panasonic
KX-T, KX-TA or KX-TD series, set to
“EMSS”.
AC Adaptor
(KX-All)
To Telephone
Line Jack (RJ14C)
or PBX.
Telephone Line Cord
THE AC OUTLET POWER SOCKET SHOULD BE LOCATED NEAR
THIS EQUIPMENT AND BE EASILY ACCESSIBLE.
N ote :-------------------------------------------------------------------------------------------------
- USE ONLY Pana,sonic AC ADAPTOR KX-A11. The adaptor must remain
connected at all times.
- The AC adaptor may feel warm during use. This is normal.
- The unit will not function during a power failure.
- This unit cannot be connected in parallel with a single line telephone.
- If the unit does not operate after connecting the AC Adaptor to the AC Outlet,
disconnect the AC Adaptor once and re-insert it.