Getting started – Panasonic TX-80V95Z User Manual
Page 3
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Getting Started
Connect the Aerial
The RF (Aerial) Input impedance of this television is 75Q. If your aerial lead is 300Q ribbon (two
wires separated by a flat plastic sheet) you will require a 300Q/75Q Baiun in order to connect
your aerial to the television.
3000 / 750 Baiun
(Not supplied)
RF-IN
Terminal
For your safety any external aerial should be installed by a reputable qualified installer and
should comply with Australian Standard AS1417.1 or International Standard EIS597-1.
Connect the Power Plug
The TC-80V95A is designed for the Australian Standard Mains Voltage of 240V 50Hz.
The TX-80V95Z is designed for the New Zealand Standard Mains Voltage of 230V 50Hz.
NOTE:
If the television is not going to be used for an extended period, remove the power plug from the
wall outlet.
Turn on the Television
Power Switch
Push the Power Switch to turn the television ON. Sit back and enjoy your new Panasonic
television.