Panasonic RX-FT560 - Manual (Page 6)

1. Set the Function Selector to “RADIO”.
2. Set the Band Selector to the desired radio band.
3. Tune in your favourite station using the Tuning Control.
4. Adjust the Volume, Graphic Equalizer Controls and XBS
Level Control to the desired settings.
(Refer below for the operation of the Graphic Equalizer.)
5. The radio can be turned off by setting the Function
Selector to “TAPE/To^”.
Notes:
•To receive FM stereo broadcasts, set the Band
Selector to “FM STEREO”. The FM Stereo Indica­
tor will light during stereo broadcasts.
•if FM stereo reception is poor (excessive noise, FM
Stereo Indicator flickers), set the Band Selector to
“FM". This will reduce the noise and provide clear
reception; however, the broadcast will not be heard
in stereo.
Antennas
FM:
Pull out the Telescopic Antenna and adjust its length and
angle for optimum reception.
n Graphic Equalizer
It allows you to tailor the frequency response of the unit to
compensate for room acoustics aid other factors which
affect frequency response. The overall tone can be altered
by adjusting the controls which control the following fre­
quency bands;
100 Hz, 1 kHz, 10 kHz.
Positioning the control to the "-t-" side of the detent wilt
amplify the corresponding frequency band; the side will
attenuate it.
If the XBS Switch is set to “ON", the 100 Hz Control
functions as an XBS Level Control.
B Extra Bass System
When the XBS Switch is set to “ON", the dynamic low
frequency ranges are boosted. Adjust the level by using the
XBS Level Control. It is amplified at low volume levels and
attenuated at high volume levels. Using this system with
Graphic Equalizer helps you to get more dynamic sounds.
AM:
The sensitive ferrite core antenna inside the set will provide
excellent AM reception in most areas. For optimum recep­
tion, turn the set in the direction which gives the best results
since the ferrite core antenna is directional.
Notes:
•The Extra Bass System effect may be different
according to the program content of the music tape.
•When you playback the music tape which was
recorded with a high level, the playback sound may
be distorted. In this case, adjust with the XBS Level
Control.
- 6 -