Panasonic ER147 - Manual (Page 7)

Blade Maintenance
<Always clean the blade after
each use>
1) Unplug the power cord and use
the cleaning brush to remove the
cut hairs from the clipper body
and from around the blade (Fig.
8
)
2) Remove the blade and brush off
the cut hairs from the blade
edge.
3) Brush the cut hairs out from the
gap between the fixed blade and
the moving blade.
Press down on the lever for
cleaning in order to raise the
moving blade, and brush the cut
hairs out from the gap between
the blades. (Fig. 9)
4) Apply a few drops of the oil to the
points indicated by the arrows in
Fig. 10.
5) Remount the blade on the clipper
body.
Special attention when
charging
• Avoid charging the battery at
temperatures below CC or above
40“C.
• Avoid charging the battery in
direct sunlight or near a radiating
heat source.
<Cautions>
• Clean the housing using only a
cloth slightly dampened with
water or a mild soap solution.
• Never use a caustic solution.
• Never submerge the hair clipper
in water.
• Keep out of the reach of children.
• Do not use to trim the hair of a
pet.
• The hair clipper may become
warm during operation and/or
charging.
This is normal.
• Avoid grabbing the hair clipper by
the power cord, as it may
become
detached, causing
damage or injury.
• Never tamper with moving parts.
• If the hair clipper is not working
properly, have it inspected at an
authorized service center.
• Use the ER147 hair clipper with
the RE5-70 adapter only.
Note:
The Supply cord of the charging
adaptor RE5-70 cannot be replaced;
if the cord damaged, the appliance
should be discard.