Panasonic PV-M2738 - Manual (Page 10)

On-Screen Displays (OSD)
Channel & Function Display
Whenever the channel is
changed, the channel
number will appear tor a
few seconds on-screen.
(Some station names may
also appear.)
When a function button is
08
WNET
Combination VCR mode will be
displayed.
• When a recording is started, both REC and
the channel number will appear together.
Menu Screen
1
Press MENU to
display the MAIN
MENU.
2
Press and
MENU to make your
selection {see page 8.)
• To get the most from each feature, please read
the Operation Manual before attempting any
operation.
SELECT KEY
SET :MENU KEY
VCR Status & Clock Display
Press DISPLAY to display and remove the
overlay shown below.
Function
Status
Current
Time
Rec Time
Remaining
(OTR mode
only see
page 17.)
X
REC 12:00AM WNET
0:25 0:00:00
(►STEREO 1 SLP >
S^SAP 1 N
MONO
Channel &
Call Letter
^Tape Speed
Receivable
Broadcast Types
(See page 21.)
Tape Counter
Warning and Instruction Displays
These displays will alert you of a missed operation or
provide further instructions.
If no active channels are
found for CHANNEL
MEMORY...
(see page 5.)
If you attempt to set or
review a Timer Recording or
set the On-Timer and the
Clock is not set...
(see pages 8, 9.)
If you press REC on the
remote control or the
Combination VCR, and a
cassette is inserted with no
record tab...
(see page 17.)
If you press STOP
during a Timer
Recording...
(see page 19.)
If you press PLAY, FF,
REW, or REC on the
remote control or the
Combination VCR without
a cassette inserted...
(see pages 15, 17.)
If the Combination VCR is
not in Stop mode or a
cassette with record tab is
not inserted two minutes
before a Timer Recording
is about to begin...
(see pages 18, 19.)
If head cleaning becomes
necessary while playing
back a tape...
(see page 25.)
NO CH FOUND
PLEASE CHECK ANTENNA
CABLE CONNECTION THEN
PUSH CH UP KEY AGAIN
PLEASE SET CLOCK
BEFOPE PROGRAMMI NQ
CHECK CASSETTE
RECORD TAB
TO CANCEL TIMER REC
HOLD
down stop key
FOR APPROX 3 SEC
NO CASSETTE
PLEASE INSERT A CASSETTE
PLEASE PREPARE
FOR T IMER BEC
VIDEO HEADS MAY
NEED CLEANING
PLEASE INSERT HEAD
CLEANING CASSETTE
OH HEFER TO MANUAL
END:PLAY KEY
Blank Tape/ No Video Signal Indication
When a blank section of tape comes up in Play
mode, or the selected channel has no
broadcast signal, the TV screen will turn a solid
blue.
If you press a function
button other than
STOP/EJECT or POWER
while the Combination VCR
is in VCR Lock mode...
(See page 20.)
VCR LOCK ACTIVATED
10