Panasonic PORTABLE STEREO RX-DS16 - Manual (Page 8)

■
I
I
?
I
'iS
e
FM MODE/BP
Listening to radio broadcasts
Listening to programmed stations
(Preset tuning)
Make sure you have completed the procedure for "Presetting radio
broadcasts" (on page 7).
n Press BAND to select “FM” or “AM”.
Every time you press the button: FM AM
Press TUNE MODE to display the preset indicator.
The unit is set to the preset tuning mode.
Press -/K^ or +/►►! to select the preset channel.
Adjust the volume.
Listening to broadcast stations which have
not been programmed (Manual tuning)
F^ress BAND to select “FM” or “AM”.
Every time you press the button: FM AM
Press TUNE MODE to clear the preset indicator.
The unit is set to the manual tuning mode.
Press or +/►►! to tune in the station.
Adjust the volume.
Automatic tuning:
This is a simple way of tuning in stations that have not been preset.
Keep
or +/►►) depressed, and release it when the frequency
display starts to change. A station with good reception is automatically
selected and the selection process then stops.
To stop automatic tuning, press or +/►►) again,
OBI
Automatic tuning may stop without a station having been tuned in
when interference is encountered on neighboring airwaves. In such a
case, tune in a station by tapping or +/►►!.
Adjusting the antennas Q
For FM reception:
Pull out the telescopic antenna and adjust its length and angle for
optimum reception.
For AM reception:
Turn the unit in the direction which gives the best results.
Reference
Radio broadcasts may be hard to receive in a moving vehicle or in a
building because the signal may be weakened. In such cases, use the
unit near a window.
When there is a lot of noise in an FM stereo
broadcast Q
Reduce the interference by setting the sound to monaural.
Example:
When an FM stereo program is being received;
Press FM MODE/BP.
"iMONor is displayed.
To return to stereo reception, repeat the same procedure and turn off
the IMONOI display.