Removing and installing lower plate, Replacing headlight bulb, Cambiar y insertar de ia base inferior – Panasonic MC-V7341 User Manual

Page 17: Cambio de ia bombilla

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Removing and Installing Lower Plate

Cambiar y insertar de ia base inferior

>- Before servicing anv parts, disconnect vacuum from

electdcfll outlet

Desenchufe la asoitadom de la toma de^pared antes de
hacerles servicio a las piezas

TWo

Screws

Two Locking Tabs

Dos lengüetas de cierre

removed to protect floor

Siempre coloque un papel debajo de la boquilla para

proteger el suelo cada vez se quita la base inferior

>■ Place handle in upright position and turn vacuum

over to expose lower plate

Coloque el mango en la posición vertical y vuelque la

aspiradora para exponer la base inferior

>■ Release lower plate by removing two (2) screws and

pressing inward on two (2) locking tabs

Para liberar la base inferior, quite los dos (2) tornillos y apriete hacia adentro en las dos (2)
lengüetas de cierre

>- Remove lower plate and remove any residue that may exist in belt area

Quite la base inferior y quite los residuos que exista en el área de la correa

Reinstall lower plate by hooking front end of lower plate into slots on front of nozzle
housing

Para reinstalar la base inferior, enganche el extremo delantero de la base inferior en las ranuras
en el montaje delantero de la boquilla

Make sure all wires are routed properly and not pinched
Asegúrese de que las alambres estén dirigidas bien y no estén apretadas

'*■ Press lower plate until locking tabs snap into place then replace two (2) screws

Apriete la base inferior hasta que las lengüetas hagan clic en su lugar y luego reemplace dos (2)

tornillos

Replacing Headlight Bulb /

Cambio de ia bombilla

Bulb Socket Assembly

Casquitio portalámparas

>> Remove lower plate

Quite la base inferior

>• Grasp the bulb socket assembly and pull upward while moving

it back and forth

Agarre el casquillo portalámparas y levante al moverlo hacia trasera

y delantera

Remove old buib from the socket by pushing in whiie turning

counterclockwise

Quite la bombilla vieja del casquillo portalámparas al empujar hacia
adentro y rodar en el sentido contrario de las agujas de reloj al mismo tiempo

>- Repiace bulb by pushing in while turning clockwise

Reemplace la bombilla empujando hacia adentro y rodando en el sentido de tas agujas de reloj al

mismo tiempo

>> Only use a bulb rated 130 V AC-15 Watts or less

Use solamente una bombilla de 130 VAC-15 vatios o de menos voltios

>■ Replace bulb socket assembly into nozzle housing by pushing it back down into siot /

Reemplace el casquillo portalámparas en el montaje de boquilla empujándolo hacia abajo en la
ranura

Reinstall lower plate

Reemplace la base inferior

-

17

-

Advertising