Setting the speaker impedance – Yamaha HTR-5950 User Manual
Page 30
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
CONNECTIONS
Setting the speaker impedance
CAUTION
If you are to use 4 or 6 ohm speakers, set “SP
IMP.” to “6QWIIN” as follows BEFORE using this
unit.
4
Press STRAIGHT (EFFECT) on the front
panel repeatedly to select “6nMIN”.
The following display appears in the front panel
display.
1
Make sure this unit is set to the standby
mode.
See page 27 for details about turning on this unit or
setting it to the standby mode.
2
Press and hoid STRAiGHT (EFFECT) on the
front panei and then press STANDBY/ON to
turn on this unit.
This unit turns on, and the advanced setup menu
appears in the front panel display.
While holding
down
"fay n
5 Press STANDBY/ON on the front panel to
save the new setting and set this unit to the
standby mode.
Note
The setting you made is relfected next time you turn on this
3
Press PROGRAM <] / !> on the front panel
repeatedly to select “SP IMP.”.
The following display appears in the front panel
display.
'.
i
PROGRAM I -
f
26