Power off procedure, Set the mains switch to off, If you were using a sound system, turn it off – Yamaha disklavier Mark II XG Series User Manual
Page 14: Installing batteries in the remote control, Battery replacement, Using the remote control, Chapter 4 using the remote control
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Turn your sound system on if you will be playing back Ensemble songs.
Your Disklavier is now ready for use.
Power Off Procedure
Press the [STANDBY - ON] button on the Control Unit.
Set the MAINS switch to OFF.
If you were using a sound system, turn it off.
Operating the Disklavier’s MAINS switch is ehdctively the same as disconnecting the
power cable from an AC wall outlet. So if the Disklavier is used regulaiiy, you only need
to use the [STANDBY - ON] button on the Control Unit. If the Disklavier is not going to
be used for a long period, set the MAINS switch to OFF.
Note:
The [STANDBY - ON] button on the control panel must be switched off
before switching off the MAINS switch so that “soft mode”, if u.sed, is
released. If soft mode is not released, the keyboard will become uneven, and
the piano action will be unfit for playing. See “Adjusting the Volume” on
page 26.
When the Disklavier is powered off, wait at least 5 seconds before powering on again.
14
Chapter 3 : Setting Up Your Disklavier
Chapter 4
Using the Remote Control
The Disklavier is equipped with a remote control which allows convenient control from almost anywhere in
the room. This chapter provides notes on handling the remote control.
Installing Batteries in the Remote Control______________
Before the remote control can be used, the two batteries supplied with the Disklavier must be installed.
Remove the battery cover from the rear of the remote control (shown left), and install the batteries (shown
right). Then, replace the cover.
A diagram inside the batteiy compartment shows which way they should be installed. Make sure that you
insert the batteries coiTectly.
Battery Replacement
When the remote control fails to work from a distance, replace the batteries.
Replacement batteries should be UM-3, AA, R6P, or LR6 type.
Always replace both batteries.
If the remote control is not to be used for a prolonged period of time, remove the batteries to
prevent possible damage by battery leakage.
Using the Remote Control
To use the remote control, point it at the remote control sensor on the Control Unit, as shown below, and
press a button.
Installing Batteries in the Remote Control
1 5