Caution: to avoid damage to the chair, Caring for the massager – Panasonic EP574 User Manual
Page 5
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
CAUTION: To avoid damage to the chair
1 □□ not sit on or drop the controller Do not pull the controller cord or the power cord Be careful not I
d
catch the cord of the controller between the arm rest and the chair back
2 Do not treat the chair roughly, such as forcing the reclining lever or the legrest extending lever, turning
the chair on its side, turning the chair over and standing on it
3 Do not treat the covering roughly
■ Keep sharp or pointed objects away from the cloth of the chair Be careful not to drop lit ashes or
matches on the chair
■ Exposure
I
d
direct sunlight can cause fading or
a
change in color
of
the covering
4 If the massager functions abnormally, immediately lurn off the power and have the massager checked by
an authorized service center
5 Do not attempt to repair the massager yourself
B Do not repeatedly operate any switch at short intervals II may cause the switch to malfunction
7 Some sounds may be heard coming from the massager while in use This is due to the structure of the
massager This is a normal condition
B Make sure that there are no obstacles behind the chair when reclining it The chair can be reclined lo the
maximum angle of 170' If the back hits a wall or pillar, it may malfunction Be sure to have ample space
behind the chair
9 When excessive pressure is applied to the massage heads, they may stop moving for safely When
moving the heads up from the lowered position, the body weight may stop the heads movement In such
case, slightly lift the body and let the heads move up
10 After each massage, slide power switch in rear of massager to “off” position and turn the lock switch to
"lock" position
NOTE Maximum user weight is 264 lbs (120 kg)
CARING FOR THE MASSAGER
• If the covering becomes soiled, dampen with liquid
soap and then brush the surface, wipe with a cloth
dampened with water Allow lo dry naturally If the
plastic portions become soiled use luke warm water
with liquid soap on a soft cloth to clean the surface
Do not use thinner, benzene or other solvent type
cleaners