Panasonic NV-D48 Series - Manual (Page 20)

TIMER RECORDING BY USING THE DIGITAL SCANNER
Tracing the Bar Codes
©CHANNEL D>@DATE >@STARTTIME l>@ENDTIME
1 □ iinii 1□ llili 0 llilli @ iiiiii
; □ HIH 1□ iiimi @ Hinil
3 □ OF 3B- laiML.
IHIIMir
Mlilll @ NIilli 31 ~OT
4 JIH 11(11 4
□ lllllli @1111 mm 'zi
5 □ lllllill 5□ illli iiiiiinr @ [0)11 33 m «111
e □ lililí E□ lillli Hi liilllii
ria_iiu|JMJjLL. IWiMliriT 34 B 01
7 □ iilli 7 □ illll llilllllll @ limili sHiSifK
8 □ lililí B□ mill imniii n jlMHIli
36
B ¡III
Example: When programming a timer recording for a
programme that will be broadcast on channel
position 4 on the 3rd of the month, from 7:02 to
7:35, trace the bar codes in the order of the
numbered arrows shown below.
^ Trace the bar code for “CHANNEL”.
>>
ON
W n - * - -
OFF
___ __________________________________
0 Trace the bar code for “DATE”.
ON OFF
U j -
L_____ _________________________________
0 Trace the bar code for “START TIME”.
ON OFF
tj -) ~hnn
1 J D t - U U
J
0 Trace the bar code for “+MIN”,
ON OFF
y T i n z t
1 J D h U L
V_______
J
0 Trace the bar code for “END TIME”.
f
ON OFF
U D Z t
1 D D hlJL
I J l l
h J U
V___________
J
0 Trace the bar code for “-i-MIN”.
f
ON OFF
U T i n z t
t J D t ‘ U L J J
\ _____________________________________
_____ J
•When setting to a minute between 1 and 29, trace the
appropriate “+MIN” bar code after tracing the 0 bar
code.
•When setting to a minute between 31 and 59, trace
the appropriate “+MIN” bar code after tracing the ®
bar code.
•The “Bee Bee Bee Bee Beeeeep" sound signals
that the scanner is now ready for data transmission.
•When a timer bar code with or ® minutes is
traced for the end time, the “Bee Bee Bee Bee
Beeeeep” sound which indicates reading comple­
tion is heard. When subsequently tracing a “-t-MIN”
bar code after tracing or to choose another
minute setting, the reading completion sound will be
heard again.
•When no sound is heard, read the bar codes once
again.
•If more than one bar code is read in the same group,
only the last code will be effective.
•The bar codes for the time from “0:00” (midnight) to
“4:59” in the morning are on the back of the
Programming Sheet.
•If the “CANCEL” bar code is read, all bar codes that
have been read so far will be cancelled.
20