Panasonic ES882 - Manual (Page 8)

Replacing the system outer foil
^ee fig. 7)
Squeeze the system outer foil re­
lease buttons and lift the system
outer foil upward to remove it. To in­
sert the new system outer foil, press
down until it snaps into place.
Replacing the inner blades
(see fig. 8)
Press the foil frame release button
to pop open the foil frame. Pull the
foil frame vertically out of the upright
shaver. Remove the inner blade one
at a time by grasping it firmly at both
ends and pulling straight away from
the shaver. To insert the new inner
blades, hold the blade one at a time
at both ends and press downward
until it snaps into place.
Caution
Do not charge the shaver where the
temperature is below 0°C (32“F) or
above 40°C (104°F), where it will be
exposed to direct sunlight or a heat
source, or where there Is a lot of
moisture.
Use only the included shaver charg­
ing adaptor RE3-66 to charge the
ES882 shaver.
The supply cord of the charging
adaptor cannot be replaced; if the
cord is damaged, the appliance
should be discarded.
Dry the shaver completely before
setting it in the charging adaptor.
Keep the charging adaptor away from
water and handle it only with dry
hands. Do not use an extension cord
to connect the charging adaptor to
an outlet.
Do not place any metal objects like
coins and paper clips on the charg­
ing adaptor as they will become
warm.
Grip the plug when disconnecting the
charging adaptor from a receptacle;
tugging on the cord may damage it.
Store the charging adaptor and its
cord set in a dry area where it will be
protected from damage.
The outer foil is very thin. If handled
improperly, it can be easily damaged.
To avoid personal injury, do not use
the shaver if it has a damaged foil or
inner blade.
Wash the shaver in tap water. Do not
use salt water, detergent or boiling
water. Do not submerge the shaver
for a long time.
Do not wipe it with thinner, benzine
or alcohol. Clean it by cloth with
soapy water.
Do not take the housing apart as this
can affect the watertight construction.
Specifications
Power source: 100-120/220-240V
AC, 50-60 Hz (Automatic voltage
conversion)
Motor voltage; 2.4 V DC
Charging time: 1 Hour
Household Use
READ ALL INSTRUCTIONS
BEFORE USE.
FOR YOUR CONVENIENCE, WE HAVE ESTABLISHED A TOLL-FREE
NATIONAL ACCESSORY PURCHASE HOT LINE AT 1-800-338-0552.
8