Panasonic OMNIVISION PV-M2066 - Manual (Page 25)

VCR Plus+ programming allows you to set most items of a timer recording by simply entering a special code found in TV GUIDE
magazine as well as the TV listings in selected newspapers. In order for the Combination VCR to read this special code, some set up is
required. A Guide (VCR Pius+) channel number is assigned to each iocai broadcast and cable station. Because this number sometimes
differs from the channel your TV receives the station on, it is necessary to program the Combination VCR with local channel information.
NOTE: Complete the steps on this page if your
VCR hook-up resembles “B” on page 24.
Prepare a list like the example below.
This list will help you smoothly enter the information
needed in step(3)at right.
You will need the following to complete the list:
■ A line up of normal and/or cable stations you
receive along with the channel numbers your TV
receives them on. A cable channel line-up chart
is supplied by your cable company.
■ A list of Guide (VCR Plus+) channel numbers
assigned to the stations you receive. This list is
available in TV
Guide and the TV listings found
in selected newspapers.
Make a chart with 3 columns like the example
below. In the left column, fill in the name or call
letters of the stations you receive.
2 In the middle column, fill in each station's
assigned Guide (VCR Plus+) number found in
TV Guide, newspapers, etc.
O In the right column, fill in the channel number
that your TV receives the station on from your
channel line-up.
EXAMPLE ONLY
Broadcast or Cable
Station Name
Assigned
Guide
(VCR PIUS+)
channel no.
Channel no.
your TV
receives the
station on
HBO 33 15
Nickelodeon 38 20
CBS 04 04
FOX 11
VCR Plus-i- Channel Set Up
(For connection B on page 24 only)
MENU
Push MENU
to display the
menu.
Rotate and push
the WHEEL
to select “CH”.
SELECT
SET
MAIN MET
1
AJ
o
diom A
©
CLOCK
: ROTATE WHEB.
PUSH WHEEL
Rotate and push
the WHEEL to
select VCR Plus+
CH SET UP.
------SET UP CHANNEL --
AhfTENNA SYSTEM : CATV
AUTO SET
SELECT
SET
END
ROTATE WHEEL
PUSH WHEEL
PUSH MENU KEY
IMPORTANT NOTE:
For this step, use the list you prepared. You may leave lines
blank if, you don’t receive that station, or the GUIDE CH
number and the CATV (or TV) CH numbers are the same.
Push the
WHEEL to
move the
shaded area on
the right side.
VCR PIUS+ CH SET UP
GUIDE CH CATV CH
GD
02
SELECT
SET
END
ROTATE WHEEL
PUSH WHEEL
PUSH MENU KEY
Then, Rotate the Wheel
to change CATV CH number.
Next, Push the Wheel
to enter CATV CH number.
Now, Rotate the Wheel to continue.
Repeat this operation until the list is complete.
To Make Corrections
Rotate and push the Wheel to select the incorrect CATV or TV
CH number. Then, Push CLEAR to delete the numbers.
Now, use the Wheel to re-enter the channel.
MENU
Push MENU twice to
exit the VCR Plus-i-
CH SET UP mode.
Make your entries within 5 minutes or the
Combination VCR will leave this mode.
Once local channels have been programmed, they will
stay in memory, even in the case of a power failure.
25