Panasonic mc-v9620 - Manual (Page 12)

TO REMOVE BELT
□
M
3. Turn POWER
NOZZLE over. To
remove cover, insert
screwdriver at cover
tabs on both sides and
twist to release tabs.
1. Remove light cover
and light bulb as
shown under “LIGHT
BULB CHANGiNG.”
2. Unscrew the two
(2) POWER NOZZLE
cover screws.
4. Turn POWER
NOZZLE right side up.
Press handle release
pedal and lower the
swivel. Tilt cover for­
ward from back until
front snaps free.
5. Carefully
insert and twist
screwdriver at
each agitator
support to free
brush from
base.
A
CAUTION
When you remove the agitator
supports, a small metal washer on
each end may come off. DO NOT
lose these two metal washers.
6. Remove worn belt.
7. Slide agitator
supports off to check
and clean agitator
support areas. See page
11 for picture of com­
plete agitator assembly.
TO REPLACE BELT
2. Install new
belt in belt
groove on the
agitator
assembly, then
over the motor
shaft. Be sure
belt is under
the belt guard.
1. Slide washers
and agitator
supports onto
agitator assembly.
3. Insert both front
support tabs into
the base slots. Then
snap agitator
supports into place.
See page 11.
5. Tilt cover to back.
Press cover firmly
until rear tabs snap
into place. Turn
POWER NOZZLE
over. Replace the
cover screws and
lower the pile height
adjustment rollers
Into place. Replace
light bulb and cover.
4. Line up front of
cover and base.
Rest cover on front
edge of base as
shown.
-10-